Filter
Top Products
3. Cabling
3-6 July 2003 8620-A2-GN20-40
Connecting an SCP Card to an SNMP Management System
Procedure
To connect an SCP card to an SNMP management system or for Telnet access:
1. Plug the end of an 8-pin modular cable into LAN SCM jack of the SIM, which
corresponds to the SCP card in Slot A of the chassis.
2. Plug the other end of the cable into the 10/100 BaseT hub connector to the
SNMP management system network.
Connecting an MCP Card to a Terminal or PC
Procedure
To connect an MCP card to a terminal or PC:
1. Plug the end of an 8-pin modular cable into SERIAL MCP of the SIM, which
corresponds to the MCP card in Slot 1 of the chassis.
2. Plug the other end of the cable into the serial port connector on your terminal
or PC.
3. Configure your terminal or terminal emulator with the following settings:
— Baud Rate = 9600
— Data Bits = 8
—Parity = No Parity
— Stop Bits = 1
— Flow Control = None
— Terminal Type = VT100
03-17431
To SNMP
Management System
ALARM
CLOCK
AB
SERIAL
SCM MCP
LAN
SCM MCP
00-16907
To Terminal Serial Port
ALARM
CLOCK
AB
SERIAL
SCM MCP
LAN
SCM MCP