Filter
Top Products
1 2
TABLE OF CONTENTS
Section
Page
1.0 Warranty Information.............................................................2
1.1 Warranty Statement
1.2 FCC Information
1.3 Service Information
2.0 General Information...............................................................4
2.1 Features
2.2 General Product Description
3.0 Configuration.........................................................................5
3.1 DIP Switch Configuration
3.3 Rear Interface Cards Configuration
4.0 Installation ..........................................................................34
4.1 The Model 1001R14 Rack Chassis
4.2 Installing the Interface Driver Board
4.3 Installing the 2701RC Into the Rack Chassis
4.4 Connecting to a DTE Device
4.5 Connecting to a DCE Device
4.6 Connecting the E1 Interface
4.7 Connecting dual Coax BNC (75ohm)
5.0 Operation.............................................................................36
5.1 LED Descriptions
5.2 Loop (V.54 & Telco) Diagnostics
5.3 Bit Error Rate (V.52) Diagnostics
Appendix A - Specifications ........................................................41
Appendix B - Cable Recommendations......................................42
Appendix C - Factory Replacement Parts and Accessories ......43
Appendix D - E1 Interface Pin Assignments ..............................44
Appendix E - DTE Interface Pin Assignments............................45
1.0 WARRANTY INFORMATION
Thank you for your purchase of this Patton Electronics product.
This product has been thoroughly inspected and tested and is warrant-
ed for One Year parts and labor. If any questions or problems arise
during installation or use of this product, please do not hesitate to con-
tact Patton Electronics Technical Services at (301) 975-1007.
1.1 WARRANTY STATEMENT
Patton Electronics warrants all Model 2701RC Series compo-
nents to be free from defects, and will at our option repair or replace
the product should it fail within one year from the first date of shipment.
This warranty is limited to defects in workmanship or materials, and
does not cover customer damage, abuse, or unauthorized modification.
This product contains no serviceable parts; therefore the user shall not
attempt to modify the unit in any way. If this product fails or does not
perform as warranted, your sole recourse shall be repair or replace-
ment as described above. Under no condition shall Patton
Electronics be liable for any damages incurred by the use of this
product. These damages include, but are not limited to, the following:
lost profits, lost savings and incidental or consequential damages aris-
ing from the use of or inability to use this product. Patton Electronics
specifically disclaims all other warranties, expressed or implied, and
the installation or use of this product shall be deemed an acceptance
of these terms by the user. In the event the user detects intermittent or
continuous product malfunction due to nearby high power transmitting
radio frequency equipment, the user is strongly advised to use only
data cables with an external outer shield bonded to a metal or metal-
ized connector.
1.2 FCC INFORMATION
This equipment has been tested and found to comply with the lim-
its for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communi-
cations. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to
correct the interference at his own expense. If this equipment does