Filter
Top Products
Completing the hardware installation 34
Model 3196RC T-DAC User Manual 2 • Hardware installation
Completing the hardware installation
This section verifies that the T-DAC hardware is operational to the point where you can begin configuring the
software settings.
Power is delivered from the CPCI chassis backplane through the 47-pin PICMG 2.11 power connectors on
the 3196RC blades. Upon insertion into the CPCI chassis, the Model 3196RC immediately powers up and
begins its boot cycle. During the boot cycle the following should occur:
1. The POWER LED illuminates, indicating normal power is being applied to the 3196RC.
2. The green SYSTEM LED begins flashing, indicating the 3196RC is operating normally.
Hardware installation is now complete. To configure the 3196RC for operation, refer to chapter 3, “Configur-
ing the T-DAC for operation” on page 35.