Filter
Top Products
Introduction 69
Model 3196RC T-DAC User Manual 4 • Operation and shutdown
Introduction
This chapter describes how to start up and power down the Model 3196RC.
Activating the Model 3196RC
The Model 3196RC is activated by completing the procedures in chapter 2, “Hardware installation” on
page 24 and chapter 3, “Configuring the T-DAC for operation” on page 35. To activate the 3196RC, follow
the procedures in those chapters.
The Model 3196RC is designed for unattended operation. Once the Model 3196RC has been installed and
configured, no further operator action is required under normal conditions.
De-activating the Model 3196RC
Perform the following procedure to deactivate the Model 3196RC.
Note
Be sure to wear an anti-static strap to prevent electrostatic damage to
the blade.
1. Unlock the handles on the front of the 3196RC by pressing the red button on each handle. The button
immediately activates the switch (turning it to an open position), while the button itself remains depressed.
Remove the blade by pushing the handles outwards.
2. Remove the Model 3196RC from the rack chassis. Place the blade on an anti-static surface.
3. Remove the rear blade from the rack chassis. Place the blade on an anti-static surface.