Filter
Top Products
Using a browser to complete Model 3196RC configuration 41
Model 3196RC T-DAC User Manual 3 • Configuring the T-DAC for operation
19. Press the left-arrow cursor key until the TOP LEVEL MANAGEMENT window displays.
20. Select
a
for Home, then press
<Enter>
.
21. Under the Current Status page, type
1
(store Config(1)) to save the changes you have just made to the con-
figuration.
This completes the initial configuration of the Model 3196RC. The next steps in configuration will be done
using your Web browser connected via Ethernet to the 3196RC.
Using a browser to complete Model 3196RC configuration
This section describes the following procedures:
• Displaying the T-DAC home page (see “Displaying the T-DAC 3196RC web administration pages” on
page 41)
• Setting static connections with DS0 mapping (see “Configuring the DS0 mapping” on page 47)
• Setting the system clocking parameters (see “Configuring the system clocking parameters” on page 45)
• Configuring the IP default gateway (see “Configuring the default gateway” on page 44)
• Configuring the T1/E1 WAN links (see “Configuring line settings and signaling for E1” on page 57 or
“Configuring line settings and signaling for T1” on page 60)
Displaying the T-DAC 3196RC web administration pages
Do the following:
1. Connect your PCs Ethernet connection to the Ethernet LAN.
2. Connect the 3196RC’s T-DAC 10/100 Ethernet connection to the Ethernet LAN.
3. At your PC, open a Web browser session. In your browser’s URL/address field type the IP address of the
Model 3196RC (for example, if the Model 3196RC’s IP address 123.124.221.10, you would type
123.124.221.10
in the browser’s URL/address field). If you do not have an IP address in your TDAC, refer
to “Initial configuration through the RS-232 control port” on page 37.
4. A login prompt will appear. In the username field type
superuser
then press
<Tab> to move the cursor to the
Password field
. In the password field type
superuser
then press
<Enter>
.