Patton electronic 3202 Modem User Manual


 
Configuring the Model 3202 32
Model 3202 User Manual 3 • Hardware installation
Configuring the Model 3202
There are three different ways you can configure the Model 3202: the serial console, Telnet, or a web browser.
Web configuration requirements
Make sure that the PC you use for configuration has an Ethernet adapter and TCP/IP installed.
The Model 3202 provides a browser interface that allows you to configure and manage the modem. After you
set up the IP address for the 3202, you can access the modem's Web interface applications directly in your
browser by entering the IP address. You can then use your Web browser to manage and configure the unit
from a PC.
Note
For detailed information on configuring the Model 3202 through the
Web interface, see Chapter 4, “Web configuration” on page 33.
Console configuration requirements
To configure the Model 3202 through the serial console, you can directly connect a terminal or a PC equipped
with a terminal-emulation program (such as Hyper Terminal) to the modem's console port.
Use the supplied serial cable (RJ-45 to DB9F) to connect the Model 3202 to a PC. After marking the connec-
tion, configure the terminal-emulation program to use the following parameters:
9600 bps
8 data bits
no parity
1 stop bit
Note
For detailed information on configuring the Model 3202 through the
serial console, see Chapter 5, “Console and Telnet configuration” on
page 69.
Telnet configuration requirements
Make sure that the PC you use for configuration has an Ethernet adapter and TCP/IP installed. The Model
3202 supports Telnet for remote configuration. The command is “telnet 192.168.1.1” . When prompted for
the username and password for remote login, use admin for username and admin for password. All display
screens are the same as serial console configuration.
The default IP address is 192.168.1.1, but you may change the IP address for your application.
Note
For detailed information on configuring the Model 3202 through
Telnet, see Chapter 5, “Console and Telnet configuration” on
page 69.