Filter
Top Products
Setup Command Menu 80
Model 3202 User Manual 5 • Console and Telnet configuration
802.1Q VLAN. To modify the VLAN rule, move the cursor to modify and press Enter.
-----------------------------------------------------------------------------
Command: setup vlan modify <1~8> <0~4094> <string>
Message: Please input the following information.
VLAN table entry index <1~8>: 1
VID value (ENTER for default) <1>: 10
VLAN port membership (ENTER for default) <111111>:
-----------------------------------------------------------------------------
The VLAN Port membership ris represented with 1 or 0. VLAN port membership is a 6-digit binary number
in which bit 0 to bits 5 represent LAN1 to LAN4, line and Sniffing ports respectively.
For example: [
setup vlan modify 1 10 111111
] means use index as 1 , VID = 10 and all six ports are the same
membership (VLAN ID=10).
Use the pvid command to change the member port to untagged members:
-----------------------------------------------------------------------------
Command: setup vlan pvid <1~6> <1~4094>
Message: Please input the following information.
Port index <1~6>:
VID value (ENTER for default) <1>:
-----------------------------------------------------------------------------
PVID (Port VID) is an untagged member from 1 to 4094 for the default VLAN.
For example:
[ set vlan pvid 1 100]
[ set vlan pvid 2 100]
[ set vlan pvid 3 100]
[ set vlan pvid 4 100]
[ set vlan pvid 5 100]
[ set vlan pvid 6 100]
This example shows that all untagged members of all ports all have the same membership (VLAN ID=100).
To modify the link type of the port, move the cursor to link_mode and press Enter. There are two types of
link: access and trunk. A Trunk link will send the tagged packet form the port. An Access link will send an
untagged packet from the port. The port index 1 to 4 represents LAN ports. Index 5 represents line, and index
6 represents Sniffing.