Filter
Top Products
38 Pelco Manual C523M-H (6/05)
Table D. ASCII Commands (Continued)
Desired Action Command Result
Start macro [1-99]Sa
Acknowledge alarm [1-9999]Ia
Send camera titles Ya[string1/…/string16]!a
Send one camera title [camera number (1-16)]
Ya[camera title]!a
Version va
Set date and time ZaMM/DD/YY/HH:MM:SSa
Starts the pre-programmed system group camera sequence (the
CM6700 supports only two macros–1 and 2).
Acknowledges an existing alarm.
Sends a series of camera titles (up to 16) to a matrix switching system.
The first string always corresponds to camera #1, then each
subsequent string (separated by a slash) corresponds to the next
higher camera number (ending with camera #16). You can choose to
send fewer than 16 camera titles; be sure to end with ]!a. Valid
characters in the string are A-Z, a-z, space, and 0-9 in ASCII represen-
tation. Strings are limited to 20 characters.
Sends one camera title to the matrix switching system. Valid characters
in the string are A-Z, a-z, space, and 0-9 in ASCII representation.
Strings are limited to 20 characters.
Returns the device’s version number.
This mode of operation command sets the date and time. Since the
date and time string might be confused with other commands, Za
comes first. This puts the receiving device into a mode that can accept
the specialized string.
NOTE:
All transmitted characters
must be
ASCII
.