Filter
Top Products
Setting Jumpers 381
Introduction
4-Port Desktop IOLAN
To change the settings, do the following:
1. Unplug the IOLAN from the electrical outlet and disconnect everything from the box.
2. Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the
case. You should see the following:
2
Power
DIP
Switch
Reset
RJ45
J11
J9
J7
J24
1
3
4
J8
J4
J5
J22
J10
J25
J23
J6
Screw
Screw
The pin with the
square represents
Pin 1 --->
3. The following table describes how to jumper the pins for line termination, fixed 5V output, and
for output equal to the external adapter input:
1 Jumper J7 and J8 J4, jumper pins 1 & 2 J4, jumper pins 2 & 3
2 Jumper J9 and J11 J5, jumper pins 1 & 2 J5, jumper pins 2 & 3
3 Jumper J22 and J24 J10, jumper pins 1 & 2 J10, jumper pins 2 & 3
4 Jumper J23 and J25 J6, jumper pins 1 & 2 J6, jumper pins 2 & 3
4. Close the IOLAN case by replacing the case lid and the two screws. You can now power it on
with the new settings.
Port/Line # Line Termination 5V Output Input Volt Output