Filter
Top Products
Using the remote control 7
English
Using the remote control
Power on and standby
Turning the display on
After plugging the display's power cable into a wall outlet, the display will
enter standby mode automatically, and the power indicator will light up red.
Press Power/standby on the remote control. The display will turn on and
the power indicator will change to green.
Putting the display to standby
When the display power is ON (the power indicator lights up green), press
Power/standby on the remote control, and the display will return to
standby mode. The power indicator will turn red.
The display still consumes about 1W of power in standby mode.
Switching inputs
1. Turn on all connected equipment or devices before selecting an input.
2. Press 訊號來源 (Input)
on the remote control to display the input source
list, and then press or to select a desired input source.
• If both Composite Video (AV) and S-Video signals are connected to the AV input
at the same time, only S-Video input will be displayed. If you wish to view the
Composite Video (AV) input in such case, remove the S-Video connection
temporarily.
• Be aware that HDMI input must be HDCP-compliant to be displayed properly.
When switching to the HDMI inputs, the display needs approximately 3 seconds
to detect the HDCP information from the signal source and no image will be
displayed during this period. This is not a malfunction.
Viewing traditional (analog) or digital programs
• To view traditional (analog) programs, press 電視 (TV) on the remote
control.
• To view digital programs, press 數位電視 (DTV) on the remote control.
The digital programs function requires a separate digital video tuner with
available signal connected.
Adjusting sound settings
Adjusting the volume
• Press 音量 (Volume) + on the remote control to increase volume. The
volume indicator will increase in length as volume rises.
• Press 音量 (Volume) - on the remote control to decrease volume. The
volume indicator will decrease in length as volume falls.
Mute setting
Press 靜音 (Mute) on the remote control to turn off the sound temporarily.
Press 靜音 (Mute) once more, or press 音量 (Volume) + to restore the sound
level.
MTS
Press 雙語 (MTS) on the remote control to toggle sound among available
modes. (The modes available will depend on the sound system being
received).
32PF1700T_96_Tuner-RC-EN.book Page 7 Thursday, April 26, 2007 5:35 PM