Filter
Top Products
Fax · Send a Fax Using Standard Settings 27
EN
7Fax
Send a Fax Using Standard
Settings
Send a Fax Using Standard Settings
Your fax message will be sent using the standard settings.
If you would like to adjust the settings yourself (for exam-
ple resolution or contrast) for a fax transmission use func-
tion Send Fax Later,page 28).
1 Insert the document.
2 Enter the desired number using the numeric keypad or
select a saved entry.
3 Press FAX or o.
Call Up Function Immediately
Send Fax Immediately
Busy Number
Loading Documents
Specifi cations for Doc uments
Unsuitable Documents!
Set Fax Transmission from the Memory
1
Insert the documents face down into the document
feeder. The lower most document will be fed in first. You
can insert up to
30 documents (80¦g/m)
at a time.
2 Push the document guide inwards, so that it lies level
on the documents.
Notice
Call Up Function Immediately
You can also call the function by pressing OK,
41 and OK.
Notice
Send Fax Immediately
You can also enter the desired number first or
dial a saved entry and then press FAX or o.
The dialling process begins immediately.
Notice
Automatic Redial
If the subscriber is busy, the device dials the
number again after some time. Press j, in order
to cancel the transmission process. After the
transmission, the device prints out a transmis-
sion report depending on the settings.
Specifications for Documents
Width of Documents 140¦–¦218¦mm
Length of Documents 128¦–¦600¦mm
Paper Weight of the
Documents
60¦-¦90¦g/m²
Capacity 30 page (80¦g/m²)
Manufacturer’s Rec-
ommendation for Op-
timum Operation
A4 · A5 · Letter · Legal
(80¦g/m²
CAUTION!
Unsuitable Documents!
Do not insert any documents into the device
that ...
... are wet, have been edited with correction
fluid, are soiled or have a coated surface.
… that are written on with a soft pencil, with
paint, chalk or charcoal.
… originate from newspapers or magazines
(printing ink).
… that are held together with office or notebook
staples or with tape or glue.
… are pasted with note papers.
… are creased, crumpled or torn.
Notice
Set Fax Transmission from the Memory
You can set whether you would like to scan and
send documents immediately or whether you
would like to send the documents from the
cache memory (see also chapter on setting up fax
transmission from the memory, page 38).
lpf-5120-5125-5135-manual-uk-int-253117544-b.book Seite 27 Mittwoch, 16. Dezember 2009 10:01 10