Filter
Top Products
60 Philips · Laserfax 5120 · 5125 · 5135
EN
Sender Identification (= Header)
The telephone number and name of the sender as well as
the date and time of the fax transmission appear in the
upper margin of each received fax.
Sending to Multiple Recipients (= Broadcast-
ing)
With this function, you can send a fax message to multiple
recipients.
Telephone number suppression (CLIR)
If you call a subscriber, your number appears on the dis-
play of the person whom you are calling. You can switch
off this function and suppress your number (Caller Line
identification Restriction, CLIR).
Time Stamp
The exact date and time of receipt appear in the page
header of each received fax. A memory buffer guarantees
that exact data are issued even after a power loss. In this
way, you can verify exactly when a fax has reached you.
Tone Dialling (= Dual Tone Multi-Frequency)
In many countries, tone dialling has replaced pulse dial-
ling, in which each number was sent as a corresponding
number of pulses. With tone dialling, a specific tone is
assigned to each key (referred to as DTMF tones).
Toner Level Memory
Your device registers the extent of toner used for every
print-out and calculates the toner level of the toner car-
tridge on that basis. The toner level is stored in each toner
cartridge. You can use different toner cartridges as well as
display the respective toner level of the toner cartridge.
Transfer Speed
CCITT/ITU has published international standards for the
transmission of data over telephone lines. All short names
begin with V, so these are also referred to as V standards.
The most important transmission speeds for fax transmis-
sions are: V.17—7.200 to 14.400 bps, V.21—max. 300
bps, V.22—max. 1.200 bps, V.22 bis—max. 2.400 bps,
V.27 ter—max. 4.800 bps, V.29—max. 9.600 bps, V.32
bis—max. 14.400 bps, V.34—max. 33.600 bps
TWAIN
(Tool Without an Interesting Name) With the TWAIN
scanner driver you can access the device and scan docu-
ments from any application which supports this standard.
USB
Universal Serial Bus (computer port)
UTC
Coordinated Universal Time (UTC) Coordinated Univer-
sal Time is the current standardised universal time used.
Starting from Greenwich in London (Zero Meridian), the
world is split into time zones. These time zones are indi-
cated with a deviance from UTC (in hours) for instance
UTC+1 for Central European Time (CET)
Warm-Up Phase
Normally, the device is in the energy saving mode (see
Energy Saving Mode). In the warm-up phase, the device
heats up the printing unit until it has reached the necessary
operating temperature, after which the copy or fax can be
printed out.
lpf-5120-5125-5135-manual-uk-int-253117544-b.book Seite 60 Mittwoch, 16. Dezember 2009 10:01 10