Filter
Top Products
4-22 SV60941 Rev. B
Menu 23:
Change
Supervisor
Password
(B700 Only)
To change the supervisor password:
1. The meter prompts “Super Pswd Change?"
2. Press Yes.
3. The meter prompts "Enter Super Password.”
4. Key in the new password. You may use numbers only
and cannot enter more than four.
5. Press Enter.
6. The meter prompts “Changed” and advances to the next
menu item.
Password protection is a feature that offers an additional
measure of security by limiting access to certain meter op-
erations to authorized personnel only.
IMPORTANT! Password protection is available only when the
meter’s accounting feature is activated and in use.
To use this feature:
1. The meter prompts “Password Enable?"
2. Press Yes.
3. The meter prompts "To Enable Press YES.”
4. Press Yes.
5. The meter prompts “Enter Super Password.”
6. Key in the supervisor's password. You may use numbers
only and you may not enter more than four. If the meter
can’t accept the password, it prompts “Error” and returns
to the “Password Enable?” prompt.
7. Press Enter.
8. The meter prompts “Enabled” and goes to the next menu
item.
NOTE: With password protection enabled, you must enter the
supervisor password to get into the meter's setup mode.
Menu 24:
Enable Password
(B700 Only)
4 • Setting Up the Meter