Filter
Top Products
8-4 SV60941 Rev. B
Moistener
(B700 Only)
(continued)
Filling Moistener
1. Pour E-Z Seal
®
solu-
tion into the fill hole of
the moistener brush
assembly.
2. Fill until the solution
level reaches the top
of the sight glass. DO
NOT overfill.
NOTE: You can use
tap water in the moist-
ener. But we strongly
recommend that, for
best results, you use
E-Z Seal
®
instead. It
prolongs the life of the
moistener brush and
reduces maintenance
requirements.
Sight Glass
Using the Moistener
1. Select the postage
value you want, just as
you normally would.
2. Open the envelope flap
and feed it under the
moistener brush as-
sembly as shown.
3. Guide the envelope up
against the rear wall
and to the right until its
lead edge reaches the
trip mark on the meter's
deck.
4. The meter will then convey the envelope through the
printer and into the stacker.
5. To fully seal some flaps, you may have to compress the
mailpiece by hand after metering.
8 • Supplies and Options