Filter
Top Products
8-5SV60941 Rev. B
Bypassing the Moistener
Keep the envelope flap closed as you feed it over the moist-
ener brush (that is, on top of the brush). See figure below,
right.
BYPASSUSE
Moistener
(B700 Only)
(continued)
Maintaining the Moistener
1. Using E-Z Seal
®
will
reduce the amount of
maintenance required.
See page 8-6 for or-
dering instructions.
2. Periodically remove
the wick assembly and
wipe excess envelope
glue off the deck with a
damp sponge or paper
towel.
3. To remove the wick
assembly, lift it straight
up and out of the
moistener as shown in
the accompanying illustration.
4. If the wick gets dirty, replace the entire wick assembly
with a new one. Remove it as described in step 3 above;
install the new one as shown. Make sure the new wick
assembly is all the way down against the deck.
Supplies and Options • 8