Filter
Top Products
User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
365
5.5.3 System Status Commands
This section describes commands used to display system information.
Command Function Mode
show startup-config
Displays the contents of the configuration file (stored in
flashmemory) that is used to start up the system
PE
show running-config
Displays the configuration data currently in use PE
show system
Displays system information NE, PE
show users
Shows all active console and Telnet sessions, including user name,
idle time, and IP address of Telnet clients
NE, PE
show version
Displays version information for the system NE, PE
Table 5-9 System Status Commands
show startup-config
This command displays the configuration file stored in non-volatile memory that is used to start up the system.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Use this command in conjunction with the show running-config command to compare the information in running memory
to the information stored in non-volatile memory.
This command displays settings for key command modes. Each mode group is separated by “!” symbols, and includes the
configuration mode command, and corresponding commands. This command displays the following information:
-Switch’s MAC address
-SNTP server settings
-Broadcast storm control settings
-SNMP community strings
-Users (names and access levels)
-Event log settings
-VLAN database (VLAN ID, name and state)
-VLAN configuration settings for each interface
-Multiple spanning tree instances (name and interfaces)
-IP address configured for the switch
-Spanning tree settings
-Interface settings
-Any configured settings for the console port and Telnet