Filter
Top Products
User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
569
switchport ingress-filtering Enables ingress filtering on an interface IC
switchport native vlan Configures the PVID (native VLAN) of an interface IC
switchport allowed vlan Configures the VLANs associated with an interface IC
switchport gvrp Enables GVRP for an interface IC
switchport forbidden vlan Configures forbidden VLANs for an interface IC
switchport priority default Sets a port priority for incoming untagged frames IC
Table 5-69 Configuring VLAN Interfaces
interface vlan
This command enters interface configuration mode for VLANs, which is used to configure VLAN parameters for a physical
interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4094, no leading zeroes)
Default Setting
None
Command Mode
Global Configuration
Example
The following Example shows how to set the interface configuration mode to VLAN 1, and then assign an IP address to
the VLAN:
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
Related Commands
shutdown
switchport mode
This command configures the VLAN membership mode for a port. Use the no form to restore the default.
Syntax
switchport mode {trunk | hybrid | private-vlan}
no switchport modehybrid -Specifies a hybrid VLAN interface. The port may transmit tagged or untagged frames.
access - Specifies an access VLAN interface. The port transmits and receives untagged frames only.