Filter
Top Products
User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
603
therefore periodically check the value of lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp notification
Console(config-if)#
lldp mednotification
This command enables the transmission of SNMP trap notifications about LLDP-MED changes. Use the no form to disable
LLDP-MED notifications.
Syntax
[no] lldp mednotification
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This option sends out SNMP trap notifications to designated target stations at the interval specified by the lldp
notification-interval command. Trap notifications include information about state changes in the LLDP MIB (IEEE
802.1AB), the LLDP-MED MIB (ANSI/TIA 1057), or oganization-specific LLDP-EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
• SNMP trap destinations are defined using the snmp-server host command.
• Information about additional changes in LLDP neighbors that occur between SNMP notifications is not transmitted.
Only state changes that exist at the time of a trap notification are included in the transmission. An SNMP agent should
therefore periodically check the value of lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp mednotification
Console(config-if)#
lldp basic-tlv management-ip-address
This command configures an LLDP-enabled port to advertise the management address for this device. Use the no form to
disable this feature.