Filter
Top Products
Genicom 3840 and 3410 ANSI Emulation
112
Sets the vertical and horizontal pitch in decipoints. Parameter (p1) is the spacing between lines and (p2) is
the spacing between characters. Unspecified parameters remain at their current values. This command does
not affect oversized printing selected by ESC [1t.
Character Set
Font And Print Modes ESC [(p1);…(pn)m
Selects print modes and fonts
P1 Printing Mode
0 normal printing – resets all modes
1 set bold print
4 set underline
5 set doublewide
10 and 11 DF
12 LQ
13 DF
14 LQ
15 Italic DF
16 Italic LQ
17 Italic DF
18 Italic LQ
19 Wide DF
22 cancel bold
24 cancel underline
25 cancel doublewide
Example: set bold print
Escape Sequence: ESC [ 1 m
Hexadecimal: 1B 5B 31 6D
Partial Line Down (Subscript) PLD
Moves paper ½ line below the current line for subscript printing.
If 8-bit control code processing is enabled then
Control Code: PLD
Hexadecimal: 8B
Subscript Printing ESC K
Moves paper ½ line below the current line for subscript printing. ESC K is also used to return to the original
line following ESC L (superscript).
If 8-bit control code processing is enabled then.