Filter
Top Products
ANSI X3.64 Emulation
30
Enable Printing of High Symbols ESC 6
Enables printing of character values 128 through 159 decimal. If printing is not enabled, these characters will
be treated as control codes. Overrides the “Characters” value in the interface setup menu.
Escape Sequence: ESC 6
Hexadecimal: 1B 36
Disable Printing of High Symbols ESC 7
Disables printing of character values 128 through 159 decimal. These characters will be treated as control
codes. Overrides the “Characters” value in the interface setup menu.
Escape Sequence: ESC 7
Hexadecimal: 1B 37
Printing of Low Symbols ESC I n
Enables printing of character values 0 through 31 decimal if they are not used as control codes for n=1, or
disables printing for n=0. Overrides the “Characters” value in the interface setup menu.
Example: The following escape sequence will disable printing of character values 0 through 31 decimal.
Escape Sequence: ESC I 0
Hexadecimal: 1B 49 30
Line Pitch
Select 8 LPI ESC 0
Sets the line spacing to 1/8 of an inch per line (8 lpi). Overrides the “Lines/Inch” value in the forms menu.
Escape Sequence: ESC 0
Hexadecimal: 1B 30
Set Line Spacing to 7/72” ESC 1
Sets the line spacing to 7/72 of an inch per line. Since the distance between print head wires is 1/72 of an
inch, this is equivalent to setting seven wire spacing. This is not particularly useful for text, but may be useful
for graphics if 7-bit graphics data is being sent. Overrides the “Lines/Inch” value in the forms menu.
Escape Sequence: ESC 1
Hexadecimal: 1B 31
Select 6 LPI ESC 2
Sets the line spacing to 1/6 of an inch per line (6 lpi). This is the normal text line spacing. Overrides the
“Lines/Inch” value in the forms menu.