Filter
Top Products
ANSI X3.64 Emulation
41
Example: The following escape sequence will load form 2.
Escape Sequence: ESC EM 2
Hexadecimal: 1B 19 32
Emulations
Select Software Interface n ESC ESC n
Selects the software interface n according to the table below.
n Software Interface
0 Test (reserved for factory use)
1 ANSI X3.64 Emulation
2 Epson FX Emulation
3 Bar Code Mode (optional)
4 IBM Proprinter Emulation
5 DEC LA120/210 Emulation
6 TTY Emulation
7 Printek Emulation
; Remote Setup Mode
< Genicom 3840
= Genicom 3410
? Previously Selected Emulation
@ Default Emulation
Overrides the “Emulation” value in the interface setup menu.
A numeric value for n may be specified in two different ways, with equivalent results: a single byte with a
value of 00 to 07 hex, or a single printable ASCII character “0” to “7” (30 to 37 hex).
If more than one emulation has been selected, ESC ESC ? will return to the previously selected emulation.
This is particularly useful when the previous emulation is unknown. Please beware that the memory (stack) is
only one level deep.
ESC ESC @ will return to the default emulation, as specified by the “Emulation” value in the interface setup
menu.
This chapter describes Epson FX emulation. If a different interface is selected, the control codes and escape
sequences described in this chapter will no longer be applicable.
Example: The following escape sequences will select Printek emulation, load form one, and then return to the
previous emulation.
Escape Sequence: ESC ESC 7 ESC L 1 ESC ESC ?
Hexadecimal: 1B 1B 07 1B 4C 01 1B 1B 3F