Filter
Top Products
Genicom 3840 and 3410 ANSI Emulation
121
Paper Shear
Paper Shear ESC [(p1);(p2);<SP>{
Parameter p1 = 1 selects the paper shear.
Parameter p2 = 1 executes a cutting sequence: If the vertical position is not at top-of-form, then a form feed
is executed. Paper is advanced to the shear position and cut. The shear position should be set from the
control panel so that paper is cut precisely at the perforation.
Escape Sequence: ESC [ 1 ; 1 SP {
Hexadecimal: 1B 5B 31 3B 31 20 7B
Printek Genicom ANSI Emulation And Genicom 3840 & 3410 ANSI
Mode Differences
The following functions in the Printek FP4000se, FM8000se and PM850 series printers Genicom ANSI
Emulation have slightly different behavior than the Genicom 3840 or 3410 ANSI mode. In most cases,
these differences will not affect the direct drop in replacement by the previously mentioned Printek printers.
ANSI Bar Codes
ANSI Bar Codes ESC [(p1);(p2);…(p12)}
Set Bar Code Parameters
Programs all barcode parameters. Barcode Parameters are stored in non-volatile memory, and all 12
parameters should be programmed once to ensure the desired results. Factory default is for Code 3 of 9.
Differences from Genicom 3840 and 3410:
p1 - Bar Code Style
This printer supports the following styles:
p1 Style
0 Interleaved 2 of 5
4 Code 3 of 9
13 UPC-A
16 Code 128 (subsets A, B and C)
p12 - Human Readable Font
Only the special barcode font is supported.