Filter
Top Products
Chapter 4 General Cleaning
112
4. Lower the transport surface by turning on the green lever on
the transport unit to the left.
Legend:
1) Green Lever
2) Fuser Unit
3) Thumbscrew (not visible in figure)
4) Holding Plate
5) Thumbscrew
5. Loosen the thumbscrews on the right and left fuser unit holding
plates.
6. Grasp the handle and pull out the fuser unit until the second
handle is visible.
7. With the other hand, grasp the second handle and remove the
fuser from the printer.
8. Place the fuser on a clean, flat surface with the cover glass
facing up.
CAUTION
Do not scratch or place your hands directly on the cover glass.
Fingerprints on the cover glass or lamps will cause them to
break.
3
1
2
5
4