Filter
Top Products
Cleaning The Developing Area
127
23. Wipe the SELFOC
®
lens by moving a Toraysee cloth (listed on
page 78) from the inner part of the printer toward you. Wipe the
lens several times until there is no more dirt on the cloth.
CAUTION
When wiping the SELFOC lens, be certain not to apply
excessive force to the drum surface potential sensor near the
SELFOC lens, as this may dislocate the sensor. (If this
happens, contact your service representative.)
NOTE: Always wipe the SELFOC lens with the unused side of the
Toraysee.
Legend:
1) SELFOC Lens
2) Drum Surface Potential Sensor
24. Install the main charger.
25. Install the cleaning unit.
26. Install the photoreceptor drum. (Refer to page 60.)
27. Install the developing unit. (Refer to page 75.)
1
2