Filter
Top Products
201
Using the Command Line Interface
For the wireless card in Slot B
You can set up to four encryption keys. This example describes setting encryption Key 2 on the wireless card in Slot B.
[Device Name]>set wifsec 4 encrypt enable encryptkey 2
<WEP key (5-13 characters long depending on card type)> encryptkeytx 2
[Device Name]>show wifsec<CR>
Figure A-13 Result of “show wifsec” CLI Command
Change Passwords
[Device Name]>passwd <old password> <new password> <confirm password> (CLI password)
[Device Name]>set httppasswd <new password>
[Device Name]>set snmprpasswd <new password> (SNMP read password)
[Device Name]>set snmprwpasswd <new password> (SNMP read/write password)
[Device Name]>reboot 0
CAUTION
!
Proxim strongly urges you to change the default passwords to restrict access to your network devices to
authorized personnel. If you lose or forget your password settings, you can always perform the Reset to
Factory Default Procedure.
Other Network Settings
There are other configuration settings that you may want to set for your AP-2500 unit. Examples are provided below.
– VLAN Management
– Change your Wireless Interface Settings
– Set Interface Management Services
VLAN Management
Add Entry to VLAN ID Table
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set vlanidtbl <index (1 or 2)> id <0 (disable) o 1-4094>
[Device Name]>reboot 0
[Device Name]>show vlanidtbl