Filter
Top Products
213
Using the Command Line Interface
SNMP Parameters
SNMP Table Host Table Parameters
When creating table entries, you may either specifying the argument name followed by argument value. CLI applies
default values to the omitted arguments. Due to the nature of the information, the only argument that can be omitted is
the “comment” argument.
Telnet Parameters
Name Type Values Access CLI Parameter
SNMP Group N/A R snmp
SNMP Management
Interface Bitmask
Interface Bitmask 0 - no interfaces
(disable)
1 - Ethernet
4 - Wireless A
8- Wireless B
15 - all interfaces
RW snmpifbitmask
Read Password DisplayString User Defined
public (default)
max 63 characters
W snmprpasswd
Read/Write Password DisplayString User Defined
public (default)
max 63 characters
W snmprwpasswd
SNMP Trap Host Table N/A N/A R snmptraphosttbl
Name Type Values Access CLI Parameter
SNMP Trap Host Table Table N/A R snmptraphosttbl
Table Index Integer User Defined N/A index
IP Address IpAddress User Defined RW ipaddr
Password DisplayString User Defined W passwd
Comment (optional) DisplayString User Defined RW cmt
Status (optional) Integer enable
disable
delete
RW status
Name Type Values Access CLI Parameter
Telnet Group N/A R telnet
Telnet Management
Interface Bitmask
Interface Bitmask 0 - no interfaces
(disable)
1 - Ethernet
4 - Wireless A
8- Wireless B
15 - all interfaces
RW telifbitmask
Telnet Port Integer User Defined
23 (default)
RW telport
Telnet Login Inactivity
Time-out
Integer 1 – 60 seconds
30 sec (default)
RW tellogintout
Telnet Session Idle
Time-out
Integer 1 - 900 seconds
900 sec (default)
RW telsessiontout