Q-Logic SANBOX2-16 Switch User Manual


 
B – Command Line Interface
Reset Command
59021-07 A B-27
D
Reset Command
Resets the switch configuration parameters. If you omit the keyword, the default is
Reset Switch.
Authority Admin session
Syntax reset
config [config_name]
factory
port [port_number]
security
snmp
switch (default)
system
zoning
Keywords config [config_name]
Resets the configuration given by [config_name] to the factory default values for
switch, port, alarm threshold, and zoning configuration. If [config_name] does not
exist on the switch, a configuration with that name will be created. If you omit
[config_name], the active configuration is reset. You must activate the
configuration for the changes to take effect. Refer to Table B-5 through Table B-8
for switch, port, and alarm threshold configuration default values.
factory
Resets switch configuration, port configuration, alarm threshold configuration,
zoning configuration, SNMP configuration, system configuration, security
configuration, and zoning to the factory default values. The switch configuration is
activated automatically. Refer to Table B-5 through Table B-10.
port [port_number]
Reinitializes the port given by [port_number]. Ports are numbered beginning
with 0.
security
Clears the security database and deactivates the active security set. The security
configuration value, autosave, and fabric binding remain unchanged. Refer to
Table B-11 for security configuration default values.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to
Table B-9 for SNMP configuration default values.
switch
Resets the switch without a power-on self test. This reset disrupts traffic and
activates the pending firmware. This command also closes all management
sessions. This is the default. To reset the switch with a power-on self test, refer to
the ”Hardreset Command” on page B-16. To reset the switch without disrupting
traffic, refer to the ”Hotreset Command” on page B-20.