B – Command Line Interface
Show Command
B-62 59021-07 A
D
InvalidDestAddr Invalid destination address detected.
LIP ALPD ALPS Number of F7, AL_PS LIPs, or AL_PD (vendor specific)
resets, performed.
LIPF7ALPS This LIP is used to reinitialize the loop. An L_Port,
identified by AL_PS, may have noticed a performance
degradation and is trying to restore the loop.
LIPF8ALPS This LIP denotes a loop failure detected by the L_Port
identified by AL_PS.
LIPF7F7 A loop initialization primitive frame used to acquire a valid
AL_PA.
LIPF8F7 A loop initialization primitive frame used to indicate that a
loop failure has been detected at the receiver.
Link Failures Number of optical link failures detected by this port. A link
failure is a loss of synchronization or by loss of signal while
not in the offline state. A loss of signal causes the switch to
attempt to re-establish the link. If the link is not
re-established, a link failure is counted. A link reset is
performed after a link failure.
Login Number of device logins
Logout Number of device logouts
LoopTimeouts A two (2) second timeout as specified by FC-AL-2.
LossOfSync Number of synchronization losses (>100 ms) detected by
this port. A loss of synchronization is detected by receipt of
an invalid transmission word.
PrimSeqErrors Primitive sequence errors detected.
RxLinkResets Number of link reset primitives received from an attached
device.
RxOfflineSeq Number of offline sequences received. An OLS is issued
for link initialization, a Receive & Recognize
Not_Operational (NOS) state, or to enter the offline state.
TotalErrors Total number of errors detected.
TotalLIPsRecvd Number of loop initialization primitive frames received by
this port.
Table B-19. Show Port Parameters (Continued)
Entry Description