21
About Your Scanner
DATA
— appears when the data skip function is active;
appears when the disconnect tone detect function is off
in the trunking mode.
SCAN
— appears when you scan channels.
LIST
— appears with numbers (
1
–
5
) during trunking.
Numbers with a bar under them show which ID scan list
banks are turned on for scanning.
SEARCH
— appears during limit, direct, service, and ID
searches, and blinks when you monitor IDs.
PRI
— appears when the priority feature is turned on.
HOLD
— appears during limit, direct, service, and ID
searches, and ID monitor holds; flashes while the scan-
ner is temporarily monitoring a programmed ID.
DLY
— appears when you select a delay.
L/O
— appears when you manually select a channel
you locked out.
K/L
(keylock) — appears when you lock the keypad.
Error
— appears when you make an entry error.
BATT
Lo
— alerts you when the battery power gets low.
MON
— appears during search modes, ID search moni-
tor, program ID monitor, or when you select a monitor
memory. The number to the right of this indicator shows
the current monitor memory.
MAN
— appears when you press
MAN
to directly enter a
channel number or frequency.
PGM
— appears while you store a frequency into a chan-
nel, while you enter a frequency range during a limit
search, or when you program trunking frequencies, fleet
maps, or ID memories while trunking.
HYPER
— appears while Hyperscan or Hypersearch is
active during a direct or limit search.
8
88
8
or
9
99
9
— appears during a limit, direct, or service
search, indicating the search direction.
20-524A.fm Page 21 Tuesday, June 27, 2000 3:41 PM