Filter
Top Products
56 Trunking Operation
Note:
If you select size code S-12, S-13, or S-14, these
restrictions apply:
• S-12 can only be assigned to Blocks 0, 2, 4, or 6
• S-13 can only be assigned to Blocks 0 and 4
• S-14 can only be assigned to Block 0
Since these size codes require multiple blocks, you will
be prompted for the next available block when you pro-
gram a fleet map. For example, if you assign Block 0 as
S-12, the scanner prompts you for
b2
, the next block
available, instead of b1. If you assign Block 0 as S-14,
you would not see another prompt because S-14 uses
all available blocks.
Programming the Base and
Offset Frequencies
To properly track Motorola VHF and UHF trunked sys-
tems, you must program the applicable
base
and
offset
frequencies for each system.
For a list of these frequencies and other scanner infor-
mation, go to
www.trunkscanner.com
and other similar
frequency resources.
1. Set the scanner for conventional scanning. Press
PROG
then
TRUNK
.
2. Press the number key of the bank where you want
to store the base frequency.
3. Repeatedly press
8
88
8
or
9
99
9
to select
E2-VHi
or
E2-UHF
, then press
E
. A previously programmed
trunked frequency appears.
4. Press
DATA (ALT)
. The preset base frequency
appears.
5. Enter a desired frequency.
6. Press
DATA
(ALT)
. The preset offset frequency
appears.
20-524A.fm Page 56 Tuesday, June 27, 2000 3:41 PM