40 Trunking Operation
To scan both trunking and conventional banks, select
the banks you wish to be active with trunking off, then
press
TRUNK
. The scanner begins scanning. To return
to conventional scanning, press
TRUNK
again.
SETTING SQUELCH FOR THE
TRUNKING MODE
Your scanner’s squelch setting is automatically adjusted
during trunking, which means it is not necessary to man-
ually adjust squelch while scanning trunked transmis-
sions. However, the squelch setting can affect how fast
your scanner acquires the data channel, and, in some in-
stances, can prevent your scanner from acquiring the
data channel at all.
We recommend you set
SQUELCH
fully clockwise before
selecting a trunked bank.
Note:
Change this setting as needed for the best perfor-
mance in your area.
STORING TRUNKED FREQUENCIES
Follow these steps to select, program, and store trunked
frequencies.
1. Press
PROG
then
TRUNK
.
TRUNK
appears and one
or more bank numbers flash.
2. Press the number key (1–10) of the desired target
storage bank. Select one of the trunk systems by
repeatedly pressing
8
88
8
or
9
99
9
to select a trunking
system type, then press
E (SVC)
. The scanner then
automatically selects the first channel in the
selected bank.
Note:
You can select from the following six systems:
You See Trunk System
E1
Motorola Type I, 800 MHz frequencies
Ed
EDACS frequencies
E2
–
800
Motorola Type II, 800 MHz frequencies
20-524A.fm Page 40 Tuesday, June 27, 2000 3:41 PM