Filter
Top Products
( 35 / 80 )
3.6.1 Connecting to an 80-pin 0.65-mm-pitch Foot Pattern
Here following is a procedure of connecting to an 80-pin 0.65-mm-pitch foot pattern on the target
system using the M3062PT-80FPB (not included). For details on the M3062PT-80FPB (not
included), refer to its user's manual.
(1) Attach the NQPACK080SB included with the M3062PT-80FPB to the target system.
(2) Attach the YQPACK080SB included with the M3062PT-80FPB to the NQPACK080SB and
secure it with the YQ-GUIDE's.
(3) Attach the CN2 side of the M3062PT-80FPB to the J4 side of the M3062PT-EPB.
(4) Attach the M3062PT-80FPB to the YQPACK080SB.
Figure 3.12 Connecting to an 80-pin 0.65-mm-pitch foot pattern
CAUTION
Notes on Connecting the Target System:
•Take care not to attach a converter board in a wrong direction. It may cause a fatal
damage to the emulator and targets system.
•The connectors of the M3062PT-80FPB are guaranteed for only 50 insertion/
removal iterations.
YQ-GUIDE (x4)
HQPACK080SB
(not included)
MCU with flash
ROM etc.
Evaluation with
actual MCU
M3T-FLX100-EPB
M3062PT-EPB
CN2 side
M3062PT-80FPB (not included)
YQPACK080SB
NQPACK080SB
80-pin 0.65-mm-pitch
(80P6S-A) foot pattern
Target system
These corners are not round.
* Available in one package
*
(4)
(3)
(3)
(2)
(1)
No. 1 pin