Filter
Top Products
( 43 / 80 )
3.6.9 Connecting to a 128-pin 0.5-mm-pitch Foot Pattern
Here following is a procedure of connecting to a 128-pin 0.5-mm-pitch foot pattern on the target
system using the M3T-F160-128NRD (not included). For details on the M3T-F160-128NRD, refer
to its user's manual.
(1) Attach the NQPACK128RD included with the M3T-F160-128NRD to the target system.
(2) Attach the YQPACK128RD included with the M3T-F160-128NRD to the NQPACK128RD
and secure it with the YQ-GUIDE's.
(3) Attach the CN2 side of the M3T-F160-128NRD to the J4 side of the M3062PT-EPB.
(4) Attach the M3T-F160-128NRD to the YQPACK128RD.
Figure 3.20 Connecting to a 128-pin 0.5-mm-pitch foot pattern
CAUTION
Notes on Connecting the Target System:
•Take care not to attach a converter board in a wrong direction. It may cause a fatal
damage to the emulator and targets system.
• The connectors of the M3T-F160-128NRD are guaranteed for only 50 insertion/
removal iterations.
M3062PT-EPB
128-pin 0.5-mm-pitch (128P6Q) foot pattern
M3T-FLX-128NRD (not included)
YQ-GUIDE (x4)
NQPACK128RD
YQPACK128RD
These corners are not round.
*
Target board
No. 1 pin
CN2 side
M3T-FLX160-EPB
HQPACK128RD
(not included)
MCU with flash
ROM etc.
Evaluation with
actual MCU
* Available in one package
(2)
(4)
(3)
(1)
(2)