Ricoh 2590 All in One Printer User Manual


 
When a Message Is Displayed
47
4
Alert Messages
This section describes the machine Alert messages.
Message Cause Solution
IEEE 802.11b
(Wireless LAN)
has a problem.
IEEE 802.11b inter-
face unit was not in-
serted when the
machine was turned
on, or it was pulled
out after the machine
turned on.
The settings are not
updated although the
unit is detected, or er-
rors are found while
accessing the unit.
Turn off the machine and check that the
IEEE 802.11b interface unit is inserted
correctly. Then, turn the machine on
again. If the message appears again,
contact your service representative.
HDD has a prob-
lem.
An error has occurred in
the hard disk drive.
Turn off the main power switch, and back
on again. If the message appears again,
contact your service representative.
USB has a prob-
lem.
An error has occurred in
the USB interface.
Turn off the main power switch, and back
on again. If the message appears again,
contact your service representative.
Ethernet board
has a problem.
An error has occurred in
the Ethernet board.
Turn off the main power switch, and back
on again. If the message appears again,
contact your service representative.
You do not have
the privileges to
use this func-
tion.
This user code is not al-
lowed to use the function
selected.
Contact the administrator.
You do not have
the privileges to
use this func-
tion.
This user code is not al-
lowed to use the function
selected.
If the message continues to be displayed
and you cannot switch the screen, press
the {Energy Saver} key. Confirm that the
display goes off, and then press the {En-
ergy Saver} key again. The display will
return to the user code entry display.
When printing under the copier or
printer function, press the {Energy Sav-
er} key only after printing has finished.
Authentication
has failed.
The entered login user
name or login password
is not correct.
Inquire the user administrator for the cor-
rect login user name and login password.
Authentication
has failed.
The machine cannot per-
form authentication.
Contact the administrator.