Various Scan Settings
104
6
Setting procedure of custom size when scanning an entire original
This section explains how to set a custom size for scanning an entire original.
To scan the entire area of an original, measure its dimensions on the surface of
the original and enter them under Original Size (X1 and Y1) and Scan Area (X3
and Y3).
The example below explains scanning an original of the following size.
You do not need to specify a Start Position (X2 and Y2). Specify it as 0 inch.
For Scan Size, enter the same value as Original Size.
A Press [Scan Settings].
B Press [Scan Size].
C Press [Custom Size].
ARE012S