Filter
Top Products
Error & Status Messages
61
6
Note
❒
If you cannot solve the problem by taking above actions, turn the printer
power off and then back on again. If this does not clear the error message,
write down the error number and the message, and contact your sales or ser-
vice representative.
Getting Printer Information over the Network
Note
❒
The optional network interface board is required to get the information over
the network
Printer Current Status
You can check the printer's current status using the following method.
❖
❖❖
❖
UNIX
Use the lpq command or stat parameter of rsh, rcp, or ftp.
❖
❖❖
❖
mshell
Use status command.
94:Error The amount of the memory
is not set correctly.
Specify the correct memory
capacity using the printer
driver. Windows 95/98
⇒
P.35 “Setting Up Options”,
Windows 3.1x
⇒
P.38 “Set-
ting Up Options”, Windows
NT4.0
⇒
P.41 “Setting Up
Options”
Message Description Comments
Ready Printer works properly. —
Add Fuser Oil The fuser oil bottle is emp-
ty.
Replace the fuser oil bottle.
⇒
P.90 “Replacing the Fuser
Oil Bottle and Ozone Filter”
Call Service There is malfunction in the
printer.
Turn the printer off and
then on.
If this doesn't clear the
problem, contact your sales
or service representative.
Change Fusing Unit The fusing unit is at the end
of its life.
Contact your sales or ser-
vice representative.
Message Description Comments