Filter
Top Products
Installing Options
14
2
Installing Options
Installing Memory Unit TypeC
R
CAUTION:
Important
❒ The memory unit can be damaged
by a small amount of static electric-
ity. Before touching it, touch some
metal to remove static electricity
from you.
❒ When the bidirectional transmis-
sion is not in operation, you must
set up the installed memory unit
using the printer driver in order to
use it. See p.37 “Installing the
Printer Driver and Software” for
setting up options. See p.48 “The
conditions of the bidirectional
transmissions” for information
about bidirectional transmission.
A
AA
A
Turn off the printer.
B
BB
B
Pull out the first paper tray (Tray
1) and take the screwdriver (A
AA
A)
from the tray. Each screw to be re-
moved requires this screwdriver.
C
CC
C
Remove the two screws locking
the printer board.
The screws are needed to lock the
printer board afterwards.
D
DD
D
Hold the handle, and carefully
pull out the printer board.
E
EE
E
Put the printer board on a flat sur-
face.
F
FF
F
Insert the memory unit diagonal-
ly into the slot (A
AA
A), and then push
it down to the direction shown
until it clicks into place (B
BB
B).
• Do not touch the inside of the
printer board compartment. It
may cause a machine malfunc-
tion or a burn.
ZFCP720E
Setup-F3_FM.book Page 14 Friday, October 5, 2001 8:27 PM