Filter
Top Products
19
2 Basic Operation
2-4 Loading the Material
Roll material must be placed at a
predetermined shaft position.
Failure to do so may
result in falling of the
roll, leading to injury.
Acceptable material widths
FJ-52
210 mm to 1350 mm (8-5/16 in. to 53-1/8 in.)
FJ-42
210 mm to 1125 mm (8-5/16 in. to 44-1/4 in.)
Secure the retainer on the left-hand side in place at the
location shown in the figure.
Tighten the screw to secure in place.
* When using roll material, the retainer on the left-
hand side should always be used secured in
place at the location shown in the figure.
1
Loading Roll Material
Rear
Left-hand retainer
100 mm (3-15/16
in.)
Line up with the core diameter of the loaded roll material and refit
the left- and right-hand media flanges.
2
Media flange
Flange retaining pin
(1)
(2)
Media flange
(3)
Line up the ridges and grooves.
(4)
76.2 mm
(3 in.)
50.8 mm
(2 in.)