Filter
Top Products
31
2 Basic Operation
+0.30%
+0.25%
+0.20%
+0.15%
+0.10%
+0.05%
0.00%
-0.05%
-0.10%
-0.15%
Making Corrections for Printing
Feed Correction
This corrects for errors in the amount of feed of the grit rollers due the type of material.
Be sure to make this setting when you have replaced the material with a different type.
Correcting the amount of feed improves the dot-positioning accuracy in the feed direction, which can help enhance image quality.
Press the [MENU] key and [
] key to make the
following screen appear on the display.
1
Press the [ ] key to make the following screen
appear on the display.
Press the [ENTER] key to start
printing a test pattern.
3
MENU
CALIBRATION
CALIBRATION
TEST PRINT
When performing test printing for feed correction, load the material correctly (see "2-4 Loading the Material"). If
the material is not loaded correctly, an accurate correction value may not be output.
Check the test pattern and choose a
value with no displacement.
4
Test pattern
Value with no
displacement
Current setting
Press the [ ] key to make the following screen
appear on the display.
5
CALIBRATION
ADJUST
Press the [ ] key to make the following screen
appear on the display.
6
ADJUST
-0.10% -0.10%
* Printing a Pattern in Steps of 0.10%
Use the [
] and [ ] keys to set the value you
checked in step 4, then press the [ENTER] key.
7
ADJUST
-0.10% +0.20%
-2.0% to +2.0%
(In steps of 0.05%)
* Test printing prints the pattern in steps of 0.10%.
You can make the setting for steps of 0.05% on the
display, but you should set the correction value to a
adjust chosen from the test pattern.
2