Filter
Top Products
18
Introduction SAM4s ER-5115 Electronic Cash Register
Loading of the Detail Paper
1. Place the key marked REG into the control lock and turn to the REG control lock
position.
2. Locate the rewind spindle.
3. Locate the printer cover key. The printer cover key is the smallest key on the key ring.
Insert this key into the printer cover lock. Turn the key, and remove the printer cover.
4. Locate and install the printer ribbon cartridge (see "Changing the Printer Ribbon
Cartridge" on page 16).
5. As you face the keyboard, notice two plastic trays behind the printer mechanism. Place
one of the rolls of printer paper into the tray on the right. Make sure the paper will
unwind from the bottom of the roll.
6. Fold back approximately 6" of paper and insert the folded end of the tape into the feed
slot just in front of the paper tray at the rear of the printer.*
7. Press the
DETL FEED key on the cash register keyboard until the edge of the paper
feeds through the printer. Run 6 - 8 inches of paper through the printer.
8. Insert the end of the paper into the slot on the shaft of the rewind spindle, holding the
spindle with the gear to the right and the shaft to the left. Wind the spindle several turns
to be sure the paper will stay on the spindle. Press the end piece of the rewind spindle
back onto the left end of the shaft.
9. Slide the axle of the rewind spindle (between the gear and the shaft) into the notch of
the printer housing. Make sure the gear on the rewind spindle meshes with the gear
on the printer.
10. Press the
DETL FEED key several more times to make sure the paper moves properly
through the printer.
* Ribbon must be in place when changing paper.