Filter
Top Products
|
Handbook 59
Remote Receive: User Function 17
This function lets you use an attached phone to tell your fax
machine to switch from telephone to fax mode so it can
receive an incoming fax. Use the keypad of an external
telephone to enter the remote receive number you have
programmed into your fax machine.
In addition, if your fax machine is in TAD mode, a caller can
enter the programmed remote receive number after leaving a
voice message. This enables the fax machine to receive a fax
from the caller. Refer to the “Answering Mode, Using Your
Fax with an Answering Machine [TAD]” section of this
handbook.
Available settings are OFF (default), 00, 11, 22, 33, 44, 55,
66, 77, 88, 99, **, and ##.
PC/Fax Switch (MFP Option):
User Function 22
This function is active only when the Multifunction Printer
Option is installed and your fax machine is set to the PC Fax
answering mode. In that case, incoming faxes are saved
directly to the PC’s disk without being printed. If the PC is
turned off or not functioning, the fax machine acts as a stand-
alone fax machine and prints incoming faxes when this PC/
FAX SWITCH function is set to ON (default). If this function
is set to OFF, the fax machine will not accept incoming faxes
when the PC is turned off or not functioning.
Monitor Volume: User Function 06
This function sets the volume for telephone line monitoring
during dialing. Available settings are LOW (default), HIGH,
and OFF.
Buzzer Volume: User Function 07
This function sets the volume of the various tones your fax
machine emits during operation. Available settings are LOW,
MIDDLE (default), and HIGH.