Filter
Top Products
Storing One-Touch & Speed Dial Numbers continued
Storing Numbers for Speed Dialing
TO begin storing numbers, press [FUNCTION], then [SPEED]. Follow the steps below.
Window Message
Your Response
Enter a 2-digit number (01-20) under which you want to
assign the telephone or fax number.
If the window says [CANCEL ? (Y/N)], a number is already
assigned to the location. Press [YES] to replace that number
and continue, or [NO] to start over with a different location.
Enter the telephone or fax number. You can use any key
on the dial pad, including [ * ] and [#].
Pressing [REDIAL/PAUSE] between numbers adds a 2-
second pause each time it is pressed. Hyphen symbol
appears on the window at the pause entry.
If you make a mistake while entering a number, press
[NO] to backspace and correct.
When the correct number appears on the window, press
[YES].
If you want to identify the telephone number with a name,
enter the desired name as described in “How to Enter
Name” on page 15.
When the desired name appears on the window, press
[YES].
If you do not want to enter a destination name, just press
[YES] without entering name.
To use the memory search function, it is recommended to enter
name.
To store other numbers, repeat the steps from beginning.
Using Address Label
There is an address label paper which
comes together with your unit. As you
store numbers into one-touch keys, make
a note of the number on the address
label to remind you of what telephone
number or fax number is stored in each
position.
Write information on the label, peel it off,
then attach it to the proper position over
the corresponding one-touch key, as
shown below.
If desired, you can use 5 additional white
labels which are not designated by
printed number.