A SERVICE OF

logo

27
Preparing for Calibration
1. Select the connected calibrator, then click “Next.”
2. If the calibrator initialization screen appears, start measurement using the calibrator.
Calibration
Calibrator
Select a Calibrator
Calibration device not found
Back Next Cancel
Connect a Calibrator
Initialize
Place a Calibrator
Connect Calibrator. The Connected Calibrator automatically appears in Select a Calibrator.
If several calibrators are connected, then select a calibrator by going to Select a Calibrator
and pressing Next.
Calibrating
Result
3. Attach the calibrator to the indicated spot on the screen, then click “Next."
NOTE
• Set the screensaver time to at least 30 minutes before starting measurement.
• The calibration process will be performed in full screen. To cancel a calibration that is in progress, press
the ESC key.
4. Measurement will be performed.
5. The settings for Color Gamut, Brightness, Black Level, White Point, and RGB
Gamma can be nely adjusted.
Completing Calibration
After calibration, you can compare the screens before and after the calibration using the After
/ Before buttons.
Result
Calibration
Edit Save Finish
Target
Red (x,y)
Green (x,y)
Blue (x,y)
White (x,y)
White Point
Brightness
Black Level
RGB Gamma
: (0.6400, 0.3300)
: (0.3000, 0.6000)
: (0.1500, 0.0600)
: (0.3127, 0.3290)
(0.6401, 0.3300)
(0.3000, 0.6002)
(0.1564, 0.0635)
(0.3128, 0.3292)
: D65
: 73 cd
: Skipped
: LUT/LUT/LUT
6495 K
73.1 cd
0.16 cd
LUT/LUT/LUT
Result
Before < After
Calibration complete. Remove Calibrator from the screen. Using the Before/After buttons
you can compare the screens before and after Calibration, Fine-tuning can be done using
After Image RGB Offset.
Place a Calibrator
Initialize
Calibrating
Add or delete images as desired using the "Custom" category.
Click “Finish” to save the calibration results to Preference on the monitor.
Using NCE (Natural Color Expert)