Filter
Top Products
Selecting Print Settings
CONFIG
• Power Save determines the length of time the printer waits after
a job is printed before it goes to a reduced power state. If the
printer is used frequently, select OFF which keeps the printer
ready to print with the minimum warm-up time. This uses more
electricity to keep the printer warm and ready to print.
• Econo Mode determines the toner quantity the printer should use
when printing. If set to ON, the printer conserves toner when
printing. The default value is OFF, which provides 100% usage.
• Auto Continue determines what action the printer should take
when a manual feed print job is sent to the printer and there is no
paper in the Multi-Purpose Tray. If set to ON, the printer will pick
up the paper from the standard Tray 1 or optional Tray 2 after
fifteen seconds. Otherwise, the printer will wait for you to load
paper in the Multi-Purpose Tray.
• Jam Recovery determines what action the printer should take
when a paper jam occurs. When set to OFF, the printer does not
reprint a page that has jammed. When set to ON, the printer
keeps the image in memory for a printed page until the printer
signals that the page has successfully printed. The printer reprints
all jammed pages.
JOB
• Timeout determines the amount of time (in seconds) the printer
will wait before printing the last page of a print job that does not
end with a command to print the page or a formfeed character.
Valid range is 0 to 300 seconds.
• Paper Type provides the printer with information about the type
of paper to be used for a print job. For the best result, set this to
the paper type you loaded in the paper tray in the printer. When
using the plain paper, set this to Default.
• SRT Mode makes the printer optimize the print quality to 1200
dpi image quality.
P
RINTING FROM DOS APPLICATIONS
D.4