Sanyo PLC-WL2503A Projector User Manual


  Open as PDF
of 78
 
54
Remote control
Thisprojectorprovides twodifferentremote controlcodes:
thefactory-setinitialcode(Code 1)andthesecondarycode
(Code 2).Thisswitching function prevents remote control
interference when operating severalprojectorsor video
equipmentatthesametime.
WhenoperatingtheprojectorinCode 2,boththeprojector
andtheremotecontrolmustbeswitchedtoCode 2.
To change the code for the projector:
SelecteitherCode 1orCode 2inthisSettingMenu.
To change the code for the remote control:
PressandholdboththeMENUandIMAGEbuttons
togetherfor5secondsormore.Afterchangingthecode,
makesuretheremotecontroloperatesproperly.
Note:
•Whendifferentcodesaresetontheprojectorandonthe
remotecontrol,anyoperationcannotbemade.In
that
case,switchthecodeontheremotecontroltofitthecode
ontheprojector.
•Ifthebatteriesareremovedfromtheremotecontrolfora
longperiodoftime,theremotecontrolcodewillbereset.
Thisfunctionallowsyoutochangebrightnessofthescreen.
Normal......Normalbrightness.
Eco ...........Lowerbrightnessreducesthelamppower
consumptionandextendsthelamplife.
Setting
Lamp control
Remote control
 previous next