Sanyo PLC-XT25 Projector User Manual


 
73
Appendix
Check the indicators for the projector condition.
• • • lighting
• • • off• • • blinking
Indicators and Projector Condition
The projector is off. (The AC power cord is unplugged.)
The projector is in stand-by mode. Press the ON/STAND-BY button
to turn on the projector.
The temperature inside the projector is abnormally high. The
projector cannot be turned on. When the projector is cooled down
enough and the temperature returns to normal, the POWER
indicator lights red and the projector can be turned on. (The
WARNING indicator keeps blinking.) Check and clean the filter.
Projector Condition
The projector is preparing for stand-by or the projection lamp is
being cooled down. The projector cannot be turned on until cooling
is completed.
POWER
green
Indicators
WARNING
TEMP.
red
LAMP
red
The projector detects an abnormal condition and cannot be turned
on. Unplug the AC power cord and plug it again to turn on the
projector. If the projector is turned off again, unplug the AC power
cord and contact the dealer or the service center. Do not leave the
projector on. It may cause an electric shock or a fire hazard.
The projector is operating normally.
The projector has been cooled down enough and the temperature
returns to normal. When turning on the projector, the WARNING
indicator stops blinking. Check and clean the filter.
WARNING TEMP. indicator
The projector is in the Power management mode.
POWER, LAMP,
WARNING, FILTER,
and LAMP REPLACE
indicators are blinking
all together.