Sanyo PLV-Z1X Projector User Manual


 
13
Projection angle can be adjusted up to 11.8 degrees with the adjustable feet.
Lift the front of the projector and pull the feet lock latches on
both sides of the projector.
1
Adjustable Feet
Feet Lock Latches
Release the feet lock latches to lock the adjustable feet and
rotate the adjustable feet to adjust the position and tilt.
2
To retract the adjustable feet, lift the front of the projector
and pull and undo the feet lock latches.
Keystone distortion of the projected image can be adjusted
by menu operation. (p20, 40)
3
CAUTION
Tilt the projector within the adjustable range in order not to shorten
the life of the lamp. Proper angle should be taken. See page 6.
Adjustable Feet
Note:
• The brightness in a room has a great influence on picture quality. It is recommended to limit ambient lighting in order to provide the best image.
• The values shown are approximate and may vary from the actual size.
This projector is designed to project on a flat projection surface and can be focused from 3.9’(1.2m) - 20.0’(6.1m). Refer to
the figure and the table below for the screen size and the distance between the projector and the screen.
40”
100”
150”
200”
154”
116”
76”
31”
Zoom (max)
Zoom (min)
20.0' (6.1m)
15.1' (4.6m)
9.8' (3.0m)
3.9' (1.2m)
Screen Size
(W x H) mm
16 : 9 aspect ratio
Zoom (min)
31”
Zoom (max)
686 x 386
3.9' (1.2m)
––-––
40”
884 x 497
5.2' (1.6m)
3.9' (1.2m)
100”
2209 x 1244
13.1' (4.0m)
9.8' (3.0m)
150”
3314 x 1866
19.3' (5.9m)
15.1' (4.6m)
200”
4419 x 2489
––-––
20.0' (6.1m)
(Inch Diagonal)
(Center)
Installation
Positioning the Projector
Installation