Filter
Top Products
49
Maintenance and Cleaning
Press MENU button to display the On-Screen Menu and select
the Setting menu by pressing the Point Up/Down button. Then
press Point Right button to enter the sub-menu.
1
Turn over the projector then pull one of the hole covers upward
gently.
2
Put the blower nozzle in the hole.
3
When finishing, pull the blower out and put the hole cover back
tightly.
4
Turn over the projector again, then press any button on the top
control or on the remote control to cancel the Cleaning function.
5
Put the hole covers back tightly
after cleaning.
Clean with using the cleaning function in the Setting menu
Press Point Up/Down button to select the Cleaning function
then press SELECT button to select the item.
The image is blacked out temporary.
While watching the position of the dust on the screen, blow air
into the projector by the blower.
6
7
8
Inside
Outside
Do not open the bottom cover except for when you clean the inside of the
projector.
Especially while operating the projector, the optical parts could damage.
*
Which hole to put the nozzle in?
When you look at the screen
● When red spots (dust) are the most remarkable, put the nozzle in
the R panel cleaning holes.
● When green spots (dust) are the most remarkable, put the nozzle in
the G panel cleaning holes.
● When blue spots (dust) are the most remarkable, put the nozzle in
the B panel cleaning holes.
When cleaning, wave the nozzle inside of the
projector back and forth.
(Do not try to force the nozzle to bend.)
Use only supplied blower and nozzle.
Do not use a commercially available air spry
not to cause malfunction of internal parts with
the cool air. We could not guarantee the mal-
function of breakage by using unsupplied tools.
When putting back the hole cover, starts from the outside hole to make the operation easier and prevent the hole
cover from damaging.
Maintenance & Cleaning