Filter
Top Products
41
Setting
For reducing power consumption as well as maintaining the lamp life,
the Power management function turns off the projection lamp when
the input signal is interrupted and no button is pressed for 30 seconds
or more.
When the input signal is interrupted and no button is pressed for 30
seconds or more, the timer display with the message "No signal"
appears on the screen. The count-down starts for 5 minutes.
When the count-down time has elapsed, the lamp will be turned off to
cool itself down. The POWER indicator is flashing red during this cool-
ing-off period. The next performance depends on setting as follows.
On ··· When the lamp has been fully cooled down, the POWER indi-
cator changes to green flashing. In this condition, the projec-
tion lamp will be turned on if the input signal is reconnected
or any button on the top control or remote control is pressed.
Off ··· The Power management function is canceled.
Power management
Rear
Rear
When this function is “On,” the picture is left/right reversed. This
function is used to project the image to a rear projection screen.
Time left until
lamp off
Power management
Capture
This function is used to capture the image being projected and use it
for a starting-up display or interval of presentations. After capturing
the projected image, go to the Logo function and set it as “User”.
Then the captured image will be displayed when turning on the pro-
jector next time or pressing the MY PICTURE (MY-P) button on the
remote control. (p11, 20)
To capture the image, select [Yes]. To cancel the Capture function,
select [No].
Capture
✔
Note:
•A signal from a computer can be captured up to XGA(1024 x 768). If selecting
1280 x 1024 at Display area in the PC Adjust Menu (p36), then the image cannot
be captured.
•A signal from video equipment can be captured except for 720P, 1035i, 1080i.
• If the Capture function fails to capture an image, the On-Screen Menu returns to the
Capture item.
• If capturing a signal which is not able to be captured, an exclamation mark appears
and the function will not be available.
• If cancelling the Capture function in the middle of operation, the last captured image
will be deleted.
This arrow indicates that there
are previous items. Select this
item and press the Point Up but-
ton to go to the previous item.
Ceiling
Mounting
This function is used to select the way of setting the projector.
Off ···· Cancels the selected way of setting
Ceiling ···· Used to project the image from a ceiling mounting the
projector. The picture is top/bottom and left/right
reversed.
Wall ···· Used to project the image from a wall-hanging projector.
The picture is top/bottom reversed.
Wall
Mounting
Setting
Power off confirmation
The confirmation dialog box to turn off the projector is displayed with
this function ON.