Filter
Top Products
42
Setting
This function is used to reset the lamp replace counter. When
replacing the projection lamp, reset the lamp replace counter by
using this function. See page 47 for operation.
Lamp counter reset
Remote control
This projector has two different remote control codes: Code 1 (initial
code) and Code 2. This switching function prevents remote control
interference when operating several projectors or video equipment
together.
When operating the projector in “Code 1”, both the projector and
the remote control must be switched to “Code 1”.
To change the code of the projector;
Set the remote control code in the Setting Menu to “Code 2”.
To change the code of the remote control;
Open the compartment lid on back of the remote control then you
will find a white switch. Slide it left or right to change the code of
the remote control.
After changing the code, make sure the remote control operates
properly. To return to the initial code (Code 1), repeat the steps
above.
Lamp mode
Factory default
This function returns all setting values except for the lamp counter to
the factory default settings.
Lamp mode
Factory default
✔
Note:
• When the batteries of the remote control are replaced, the remote control code
automatically returns to the initial code (Code 1).
Cleaning
This function is used to clean inside of the projector. Using blower
at the same time is more effective. (See p48, 49)
Press the SELECT button, then the projected image is blacked out
temporary whether input source is selected or not.
To restore to normal, press any other buttons.
To cancel, press any other button during the cleaning operation.
Select [Yes] to acti-
vate it.
Select Factory
default and this box
appears. Select
[Yes] , and the next
box appears.
Remote control Code switch
CODE1 CODE2
Remote control
This function allows you to change brightness of the screen.
Bright mode . . . . . . . . . Normal brightness
React image mode . . . The controlled brightness according
with input signal
Theater black mode . . .
Lowers brightness and reduces the lamp
power consumption.